JLC - TECREAPASS ELE.

JLC SERIES C TYPE CLAMPS

Product Description

C-type clamp is mainly used for T connection and jumping on non-bearing positision of overhead insulated conductor,aluminum hinge conductor,steel core aluminum hinge line,steel hinge wire and copper wire in 20KV overhead distribution line.The clamp is made of high-strength special aluminum alloy with good electrical conductivity.It adopts reasonable C shape structure.When the conductor is thermal expanded and cold contracted,the flexibility of C-type structure always keep the constant contact pressure between the conductor and clamp.It keeps contact pressure unchanged when the external environment and load conditions changed to meet the best connection requirements..

Product Features

●Contact performance:big contact surface between clamp and conductor,constant clamping force,DC resistance ratio between 0.85~0.9；

●Overload capacity:overload capacity is more than 2 times bigger than the approved current；

●Strong performance:high-strength materials,stainless steel bolts fastening,reliable connection,never fall off；

●Thermal cycling performance:thermal cycling performance is good,always in the DC resistance ratio-1;

●Installation:easy installation and disassembly,suitable for high altitude operations；

●Energy-saving performance,use of high-strength materials,special aluminum alloy,no electromagnetic loss,anti-corrosion,anti-oxidation.

Dimension

Installation notes

C-type clamp is non-bearing power connection fitting and can not be used as a bearing fitting；it can only be used for conductor connection,jumper,\"T\"connection and transformer leading off.Voltage levels of clamps are 380kV,10kV,35kV,110kV,220kV,can be for aluminum-aluminum,copper-copper,iron-iron connection.No need to be covered by aluminum belt. Determine the specification:carefully check conductor is the same as marked on the clamp.such as:CT-822 LGJ185-LJ120/95,LGJ95 means thatLGJ185-LJ(TJ)120 or LGJ185or LJ(TT）95orLGJ185-LGJ95 connection.

●To determine the size of the conductor:the clamp is designed to meet the coordination between conductors of different diameters.The inner arc surfaces on both sides of the hinge block are of different sizes,the big cambered surfacematches the large conductor,and the small cambered surface matches small conductor.Rules:the bus is large(main line),the block is small(Branch line);put out the articulated block to make it arching(two hinge block into a certain angle).

●Put in place the conductors and bolts:Place the conductors in the \"C\"-shaped grooves according to sizes of conductors(bowed outward).Insert the bolt from the back of the\"C\"shape so that the bolt is in the middle of the top of the hinge and tighten the bolt with a wrench.

●To ensure complete installation:tighten the bolt,there should be a clear sense of force on the last few screws;flatten the hinge pressure to withstand \"C\"shaped components.C shape should be a little deformed.

●Disassembly:Loosen the bolt,insert a screwdriver between the briquettes and the\"C\"pieces,and push up the force so that the briquettes can be turned upwards.

Installation cover

●Power frequency withstand voltage:≥ 30kV holding pressure for 1 minute without breakdown;

●Insulation resistance:≥1.0×10 1/2;

●Ambient temperature:-30℃~90℃;

●Weathering performance:keep good performance after 1008 hours artificial weather aging test;

●Tensile strength:≥200Mpa